How to Use Temporary Spoofer
This guide walks you through the correct setup to use the Temporary Spoofer safely and effectively.
✅ Step 1: Download the Loader
Download the loader from the following link: 🔗 Download Loader
🧠 Step 2: BIOS Settings (VERY IMPORTANT)
To ensure the spoofer runs correctly, you must update your BIOS configuration:
Disable Hyper-V See how to do it here: How to Disable Hyper-V
Enable Virtualization Guide available here: Enable Virtualization
⚠️ These steps vary by device. If you're not sure how to access your BIOS, we recommend watching a YouTube tutorial specific to your PC brand/model.
You will NOT be able to pass the spoofer's requirement check unless these are correctly configured.
🔐 Step 3: System Protections (Defender, Anti-Cheat, etc.)
Before using the spoofer, make sure all system protections are properly disabled: 👉 Follow this guide to complete the full protection setup: System Requirements Guide
This includes:
Disabling Windows Defender permanently using Defender Control (manual disabling is not enough—it re-enables on reboot) ➤ Download Defender Control from: https://www.sordum.org/9480/defender-control-v2-1
Ensure that any and all anti-cheat software (e.g. FACEIT, ESEA, Vanguard) is fully closed and not running.
Disable all VPN services before spoofing. Having VPNs active during the spoof process can result in blue screens. You may re-enable VPN after spoofing is complete.
🧩 Step 4: Install Required Runtime Files
To complete setup, install all Visual C++ runtime packages:
Download from: Visual C++ All-in-One Installer
After extracting, run the
.batfile as administrator
✅ Once all steps are completed, you're ready to launch the loader and start spoofing!